![]() ![]() Reach inside the loom, grab the bottom loop of the hat, and fold it back up to the pegs. You should have 1 row of loops on the loom pegs. Once you’ve reached the number of rows needed for the brim, stop wrapping and knitting. This will allow the hat to grow without being pulled up to the loom. Note: Once the hat begins to grow, after about 8 rows, you can remove the slip knot from the anchor peg and untie it by pulling on the tail. In this example, the hat is slightly longer than 5 inches. You can then see where the last row lines up with the tape measure. Pull the tape measure up along the inside of the hat until you reach the row that is still on the pegs. To measure the yarn, take your tape measure and line up the 0 inches mark with the bottom of the hat that faces inside the loom. However, this chart is only a guide, so you can also add or remove rows to make the brim longer or shorter. For example, if you make a brim for an extra large hat, you need a length of about 5 inches on the loom, which equals about 20 rows. With bulky yarn, typically 4 rows equals 1 inch. You can determine the average length, in inches and yarn rows, for the brim based on loom size in the chart pictured above. Repeat Steps 5 and 6 until the hat is long enough to make the brim. Be sure to hold your finger over each loop as you wrap so the yarn does not unravel before you knit, or hook, the yarn. As you wrap each peg, push the yarn down to the bottom of the peg. Work left to right around the loom, which turns the loom in a clockwise motion. The yarn should be wrapped tight enough around the peg so that the stitches are secure but not too tight that it is difficult to hook the yarn in Step 5. The loop should be facing outward on the peg, while the yarn facing inward creates a row that looks like a line. Pull the yarn up and around to the left of the peg, so it is in the front of the peg, facing the outside of the loom.Ĭrossing in front of the peg, pull the yarn to the right side of the peg and back inside the loom. Start with the yarn behind the back of the peg, facing the inside of the loom. To wrap the yarn, you will work from the left side of the peg to the right side. ![]() Be sure to start every row on the same peg. You can mark this peg with a sharpie so that you know that every row begins with wrapping around this peg. You will now begin wrapping the yarn around the first peg to the left of the anchor peg. Hold the loom in front of you, with the anchor peg facing toward you. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |